
Installation
Depending on your application, Counteract can be installed in one of three different ways:

THROW IN
METHOD
Counteract applications of 4oz and up can conveniently be thrown inside the tire during the mounting process. Simply open the branded Counteract bag and remove the clear bag containing the beads and place it in the tire cavity. Once the wheel begins to roll, the bag will break on its own and allow the beads to disperse inside the tire. For applications 3oz and under we recommend pouring the beads into the tire, installing through the valve stem if there is no TPMS or tearing the bag before placing it inside the tire.
INJECTION BOTTLE METHOD
Please follow instructions carefully & contact us with any questions.

STEP 1
Cut the Counteract bottle spout above the mark.

STEP 2
Remove the bottle cap and carefully pour the beads into the bottle. Attach the clear tube to the bottle cap spout.

STEP 3
Rotate the wheel so the valve stem is at the bottom, deflate the tire by removing the valve core and then place one end of the clear tube over the valve stem.

STEP 4
Invert the Counteract bottle and squeeze repeatedly to get all the Counteract Balancing Beads to flow down the clear tube into your tire.

STEP 5
Use the airline to clear the valve stem and then screw the Counteract valve core into the valve stem.

STEP 6
Re-inflate the tire to the manufacturers’ recommended pressure.

STEP 7
Screw the supplied valve cap on.
INJECTION Pump Method
Please follow instructions carefully & contact us with any questions.

STEP 1
Ensure the ball valve is in the CLOSED position. The black handle must be perpendicular to the air hose connection (90 degrees)

STEP 2
Unscrew the silver cap nut and remove the black top plate. Inspect for cracking, chips, and damages. Ensure the cap nut thread is free of cross threading and damage.

STEP 3
Open your desired amount of Counteract Balancing Beads and carefully pour them into the clear reservoir. Once you have finished pouring the beads, make sure none are on the edge of the reservoir, and that the thread is clear of debris. Proceed to press the black top plate on the pump and secure it with the silver cap nut. Finger tight is all that is needed.

STEP 4
Ensure your valve is either at the 12 o’clock or 6 o’clock position. Remove valve core from the tire’s valve stem. Allow tire to deflate to approximately half of its PSI. Do not deflate fully, unless the vehicle is supported by jack stands relieving any pressure from the wheel.

STEP 5
Rotate the pump so that the reservoir is pointing down (6 o’clock). ensure your valve is in the CLOSED position and connect your air line. When the tire is deflated. connect the chuck to the valve and make sure it is secure.

STEP 6
When ready, open the air valve to allow dry air into the tire and then begin to rotate the pump upright slowly. Be sure this is done gradually to allow the beads to easily flow out of the pump and into the tire. Be mindful not to over-inflate during this process. Once all the beads are in the tire, shut off the air valve and remove the chuck.

STEP 7
Install your valve core and torque it to the recommended 4 inch pounds. Over-torquing may damage the core causing an air leak. Proceed to air the tire up to the recommended PSI for your application.
Find the Counteract application right for you
It’s important to use the recommended weight of Counteract for your vehicle and tire. Counteract offers printable application charts, a web application calculator as well as an iOS and Android app to make determining your size easy. If you have any questions about application sizes, you can always contact us directly…we’re here to help.

Do you have questions about your installation?

Calculator